8
Joining the Center Extensions to Power Head
Module and Handle Module
Adding the extension (B) (orange connectors) to the handle module
(A) and power head module (D) creates a Power Scrubber that is
approximately 6 foot (182.9cm) in length as shown in
figure 13
, or
scrubber extension (B) (orange) and (C) (green) to make a 9ft.
(274.3cm) length as shown in
figure 13B
. (NPS1018 only)
To attach the middle module(s) to the
handle module and power head module:
1. Align the
groove
on the
outside
of the
coupling end of the power head module
(C) with the
tongue
on the
inside
of the
coupling end of the center extension (B).
See figure 14.
Push the two sections
completely together.
2. Slide the threaded sleeve (6)
(
figure 15
) on the center extension
down as far as possible and rotate the
sleeve clockwise until it stops as shown
in
figure 16
.
3. Repeat steps 1 and 2 above to attach
the handle module to the center
extension.
WARNING: Always check to make
sure that the sleeve is completely threaded on.
Not threading the sleeve completely on could result in the modules
becoming disconnected creating a hazardous condition, and a
possible leakage point. Periodically check the connections to insure
that the connections are tight.
Groove
14
15
16
13
13B
Assembly
Joining Power Head Module to Handle Module
WARNING:
To prevent accidental operation, insure that battery is
disconnected from the handle before performing the following
operations. Failure to do this could result in serious personal injury.
The four modules which make up the 18V Power Scrubber are keyed
to insure correct assembly. If a module does not smoothly attach to
another do not force fit.
Combining the handle module (A) to the power head module (D)
creates a pole scrubber that is approximately 3 foot (91.4 cm) in
length as shown in
figure 9
.
To attach the handle module to the power head module:
1. Align the
groove
on the
outside
of the
coupling end of the power head module
(D) with the
tongue
on the
inside
of the
coupling end of the handle module (A).
See figure 10.
Push the two sections
completely together.
2. Slide the threaded sleeve (6)
figure 11
on the handle head module down as far
as possible and rotate the sleeve
clockwise until it stops.
WARNING: Always check to make
sure that the sleeve is completely
threaded on.
Not threading the sleeve
completely on could result in the
modules becoming disconnected
creating a hazardous condition and a
possible water leakage point.
Periodically check the connections for
tightness.
Groove
10
11
12
9
(NPS1018 only)
90513658 NPS1018 1/15/07 2:02 PM Page 8
