12
For assistance with your product, visit our website
www.blackanddecker.
com
for the location of the service center nearest you or call the BLACK &
DECKER help line at
1-800-544-6986.
The rBrc™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the LI-ION battery (or battery
pack) indicates that the costs to recycle the battery (or
battery pack) at the end of its useful life have
already been paid by
Black & decker
.
RBRC™ in cooperation with
Black & decker
and other battery
users, has established programs in the United States to facilitate
the collection of spent LI-ION batteries. Help protect our
environment and conserve natural resources by returning the spent
LI-ION battery to an authorized
Black & decker
service center or
to your local retailer for recycling. You may also
contact your local recycling center for information on where to drop
off the spent battery.
RBRC™
is a registered trademark of the
Rechargeable Battery Recycling Corporation.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTe:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
TrOUBLeSHOOTING
problem
• Unit will not turn on.
• Battery will not charge.
• Unit will not blow air.
• Unit will not vacuum effectively.
• Unit jammed when vacuuming.
Solution
• Check battery installation.
• Check battery charging requirements.
• Install fan cover for sweeper
mode or vac tube for vac mode.
• Insert battery into charger until
green LED appears.
• Plug charger into a working
outlet. Refer to “Important
Charging Notes” for more details.
• Check current at receptacle by
plugging in a lamp or other appliance.
• Check to see if receptacle is
connected to a light switch which turns
power off when you turn out the lights.
• Move charger and tool to a
surrounding air temperature of
above 40 degree F(4.5°C) or
below 105 degree F(+40.5°C).
• Install fan cover for sweeper mode.
Refer to instructions on removing
jams. If the tool still will not blow air,
stop using the tool and take it to a
service center.
• Empty collection bag. Refer to
instructions on removing jams. If the
tool still will not vacuum, stop using
the tool and take it to a service center.
• Turn the unit off then remove the
battery. Remove the bag and
vacuum tube. Refer to instructions
on removing jams. (page 10)
