Black & Decker LSW36, Instruction Manual

Page: 4 / 36

4
IMPORTANT SAFETy INSTRUCTIONS
FOR BATTERy CHARGERS
This manual contains important safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
WARNING:
Shock hazard. Do not allow any liquid to get inside charger.
WARNING:
Burn hazard. To reduce the risk of injury, charge
only designated Black & Decker batteries. Other types of
batteries may burst causing personal injury and damage.
CAUTION:
Under certain conditions, with the charger plugged
in to the power supply, the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any buildup of metallic
particles should be kept away from charger cavities. Always unplug
the charger from the power supply when there is no battery pack in
the cavity. Unplug charger before attempting to clean.
WARNING:
• The charger supplied with this product is intended to be
plugged in such that it is correctly orientated in a vertical or
floor mount position.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging designated Black & Decker rechargeable batteries.
Any other uses may result in risk of fire, electric shock or electrocution.
• An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is 16
gauge has more capacity than 18 gauge. When using more than
one extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
Recommended Minimum Wire Size for Extension Cords
WARNING:
To reduce the risk of electrical shock; do not
expose to rain, do not use on wet surfaces. Store indoors.
SAVE THESE INSTRUCTIONS.
The label on your tool may include the following symbols.
V ...............volts A ....................amperes
Hz .............hertz W ...................watts
min ............minutes ..................alternating current
..........direct current
no ...................no load speed
..............Class II Construction
.................... earthing terminal
............safety alert symbol .../min .............strokes per minute
COMPONENTS
1 2
3
4
5
1. LSW36 Cordless Sweeper
2. On / Off Switch
3. Battery pack 4. Inner tube
5. Outer tube
6. Power Command
6