Black & Decker KC9024FB, Manual

Page: 7 / 76

7
E N G L I S H
Additional safety instructions for batteries and
chargers
Batteries
◆
Never attempt to open for any reason.
◆
Do not store in locations where the
temperature may exceed 40 °C.
◆
Charge only at ambient temperatures between
4 °C and 40 °C.
◆
Charge only using the charger provided with
the tool (see technical data).
◆
When disposing of batteries, follow the
instructions given in the section “Protecting
the environment”.
◆
Under extreme conditions, battery leakage
may occur. When you notice liquid on the
battery, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the
instructions below.
The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful.
In case of skin contact, immediately rinse
with water. Neutralise with a mild acid such
as lemon juice or vinegar. In case of eye
contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the
contacts of a detached battery.
Do not incinerate the battery.
Chargers
◆
Use your Black & Decker charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
◆
Never attempt to charge non-rechargeable
batteries.
◆
Have defective cords replaced immediately.
◆
Do not expose to water.
◆
Do not open the charger.
◆
Do not probe the charger.
The charger is intended for indoor use
only.
ELECTRICAL SAFETY
Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Never attempt to replace the charger unit
with a regular mains plug.
PACKAGE CONTENTS
The pack contains:
1 Cordless screwdriver
1 Double-ended screwdriver bit
1 Charger
1 Instruction manual
◆
Carefully unpack all parts.
◆
Please note that additional items may be found
in the carton, depending on the letter suffix
following the catalogue number of your tool.
OVERVIEW (fig. A)
1. On/off switch with forward/reverse function
2. Bit holder
3. Charger connector
4. Charger
5. Battery
ASSEMBLY
Fitting and removing a screwdriver bit (fig. B)
◆
To fit a screwdriver bit (6), push it into the bit
holder (2) until it locates.
◆
To remove a screwdriver bit, pull it straight
from the bit holder.
USE
Let the tool work at its own pace.
Do not overload.