4
g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed.
Use of the power tool
for operations different from those intended could result
in a hazardous situation.
5. Battery tool use and care
a. Ensure the switch is in the off position before
inserting battery pack.
Inserting the battery pack into
power tools that have the switch on invites accidents.
b. Recharge only with the charger specified by the
manufacturer.
A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
c. Use power tools only with specifically designated
battery packs.
Use of any other battery packs may
create a risk of injury and fire.
d. When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys,
nails, screws, or other small metal objects that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause burns
or a fire.
e. Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from
the battery may cause irritation or burns.
6. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the power tool is maintained.
Additional safety instructions for batteries and chargers
Batteries
◆
Never attempt to open for any reason.
◆
Do not expose the battery to water.
◆
Do not store in locations where the temperature may
exceed 40 °C.
◆
Charge only at ambient temperatures between 4 °C and
40 °C.
◆
Charge only using the charger provided with the tool.
◆
When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
◆
Do not incinerate the battery.
◆
Do not attempt to charge damaged batteries.
Chargers
◆
Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
◆
Never attempt to charge non-rechargeable batteries.
◆
Have defective cords replaced immediately.
◆
Do not expose the charger to water.
◆
Do not open the charger.
◆
Do not probe the charger.
The charger is intended for indoor use only.
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
Overview
1. On/off switch
2. Forward/reverse slider
3. Bit holder
Fig A
4. Charger
5. Charger connector
6. Charging base
7. Charging indicator
Assembly
Fitting and removing a screwdriver bit (fig. B)
This tool uses screwdriver bits with a 1/4" (6.35) hexagonal
shank.
◆
To fit a bit, insert the bit shaft into the bit holder (3).
◆
To remove a bit, pull the bit shaft out of the bit holder (3).
Use
◆
Before first use, the battery must be charged for at least
16 hours.
◆
Place the tool on the charging base (6) whenever it is not
in use.
Charging the battery (fig. A)
◆
Place the tool on the charging base (6).
◆
Insert the connector (5) into the charging base.
◆
Plug in the charger (4).
◆
Leave the tool connected to the charger for 7 - 8 hours.
The charger may hum and become warm while charging;
this is normal and does not indicate a problem.
