5
ENGLISH
◆
Do not store in locations where the temperature may
exceed 40 °C.
◆
Charge only at ambient temperatures between 4 °C and
40 °C.
◆
Charge only using the charger provided with the tool.
◆
When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
◆
Under extreme conditions, battery leakage may occur.
When you notice liquid on the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
- In case of skin or eye contact, follow the instructions below.
Warning!
The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact, immediately
rinse with water. Neutralise with a mild acid such as lemon
juice or vinegar. In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a
detached battery (e.g. when storing the battery in a
toolbox).
Do not incinerate the battery.
Do not attempt to charge damaged batteries.
Chargers
◆
Use your Black & Decker charger only to charge batteries
of the type supplied with your tool. Other batteries could
burst, causing personal injury and damage.
◆
Never attempt to charge non-rechargeable batteries.
◆
Have defective cords replaced immediately.
◆
Do not expose to water.
◆
Do not open the charger.
◆
Do not probe the charger.
The charger is intended for indoor use only.
Additional safety instructions for drill/screwdrivers
◆
Before drilling into walls, floors or ceilings, check for the
location of wiring and pipes.
◆
Avoid touching the tip of a drill bit just after drilling, as it
may be hot.
Additional safety instructions for jigsaws
◆
Always use the appropriate type of saw blade for the
workpiece material and type of cut.
◆
Only use saw blades in perfect condition.
◆
Always switch the tool off and wait for the saw blade to
come to a complete standstill before putting the tool down.
◆
Keep your hands well clear of the saw blade while working.
◆
Whenever possible, use clamps or a vice to secure the
workpiece.
Additional safety instructions for sanders
◆
Always wear a dust mask whenever sanding.
◆
Thoroughly remove all dust after sanding.
◆
Take special care when sanding paint which is possibly
lead based or when sanding some woods and metal
which may produce toxic dust:
- Wear a dust mask specifically designed for protection
against lead paint dust and fumes and ensure that persons
within or entering the work area are also protected.
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.
Electrical safety
Your charger has been designed for a specific mains voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Your charger is double insulated in accordance with
EN 60335; therefore no earth wire is required.
OVERVIEW (fig. A)
Motor unit
1. Variable speed switch
2. Forward/reverse slider
3. Head release button
4. Bit holder
5. Battery
6. Battery release buttons
Drill/screwdriver head
7. Torque adjustment collar
8. Chuck
Jigsaw head
9. Lock-off button
10. Saw shoe
Sander head
11. Sanding base
Charger
12. Charger
13. Charging indicator
14. End of charge indicator
