Black & Decker KA160-XE, Original Instructions Manual

Page: 8 / 12

8
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, user must
read the instruction manual.
Electrical safety
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
u
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust extraction connector
3. Base
4. Tip holder
5. Sanding base tip
6. Finger attachment
7.
8. Screw
9.
In addition, this tool is supplied with some or all of the
following accessories:
Accessory Recommended application
and use
u
Coarse grit sandpaper Fast paint, varnish and rust
removal
u
Medium grit sandpaper Paint, varnish and rust removal
u
Fine grit sandpaper
u
Sanding between coats
u
Detail sanding tips Corners and hard to reach places
u
1 OT polishing/stripping Polishing metals, stripping
wool varnish and glass cleaning
u
Grey foam pad Applying and removing polish
u
Red non-woven pad Heavy scrubbing and rust
removal
u
Grey abrasive paper Polishing plastics
u
Contour attachments
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
u
Detach the two diamond-shaped tips (10) from the
sanding sheet (11).
u
Hold the tool with the sanding base facing upwards.
u
Place the sanding sheet (11) onto the sanding base,
making sure that the holes in the sheet line up with the
holes in the base.
The diamond-shaped tip (10) can be reversed and replaced
when worn.
u
When the front part of the tip is worn, detach it from the
sheet, reverse it and press it onto the sanding base again.
u
When the whole tip is worn, remove it from the sanding
u
way as the sanding sheets.
When the sanding base tip (5) or tip holder (4) is worn, it can
be reversed or replaced. Spare parts are available from your
Black & Decker dealer.
u
Remove the screw (8).
u
Reverse or replace the worn part.
u
Fit and tighten the screw.
u
Remove the screw (8).
u
Remove the diamond-shaped tip holder (4) from the
sanding base.
u
u
Fit and tighten the screw.
u
attachment.
u
Remove the screw (8).
u
Remove the diamond-shaped tip holder (4) from the
sanding base.
u
u
Fit and tighten the screw.
u
u
u
place.
u