English
4
• For best performance on hard surface wet pickups, insert
squeegee into the bowl nozzle opening.
• For best results when using this accessory, hold the
appliance at an angle of 45° and pull it slowly towards you.
• Do not fill the bowl beyond the end of the intake chute.
If there is any liquid in the bowl, do not turn the unit
upside down, sideways, point the nozzle upward, or
shake the vac excessively.
• After picking up liquid substances clean the vac and
filter immediately. Mold and mildew may form if the
unit is not properly cleaned after wet pickups.
• If charging in a vertical position, be sure to empty all
liquid contents to avoid damage to your appliance.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Cleaning and emptying the appliance
(Fig. D - G)
WARNING:
Projectile/Respiratory Hazard:
Never use the vac without its filter.
nOTE:
The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
•
Figure
D
- Press the dust bowl release button
2
on the
handle and remove the dust bowl.
Fig. D
• Remove the deflector
6
from within the bowl.
•
Figure
E
-Remove foam filter
7
from within the
deflector
6
.
6
Fig. E
7
•
Figure
F
- Empty the debris from the bowl
4
.
• Shake or lightly brush any loose dust off the deflector
and filter.
Fig. F
4
•
Figure
g
-For a more thorough cleaning the dust bowl,
deflector and foam filter can be washed in warm soapy
water. Allow to dry before placing back into the vac.
Fig. G
4
• Place dry foam filter back into deflector and then place
deflector assembly into the dust bowl, pressing firmly to
ensure a secure fit.
• To replace dust bowl, place it back onto the unit until it
“clicks” firmly into position.
iMPORTAnT:
Maximum dust collection will only be obtained
with a clean filter and an empty dust bowl. If dust or debris
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
• It is very important that the filter is correctly in position
before use.
Accessories (Fig. H)
Your hand vac may be supplied with some of the following
accessories:
-
A squeegee tool
5
for wet clean up.
Fitting
1. Insert the appropriate accessory into the front of the
dust bowl
4
as show in Figure H.
2. Make sure the accessory is fully pushed in.
Fig. H
4
5
