Black & Decker FP2510SKT, Use And Care Book Manual

Page: 3 / 23

4
3
† 1. Food pusher (Part # FP2500-01 [white] / FP2500S-01 [black])
† 2. Wide-mouth feed chute (Part # FP2500-02)
† 3. 10-cup processing workbowl cover (Part # FP2500-05)
† 4. Reversible slice/shred disc (Part # FP2500-08)
† 5. Storage lid (model FP2500SC) (Part # FP2500S-09)
† 6. Dough blade (Part # FP2500-10)
† 7. Large, stainless steel chopping blade (Part # FP2500-03)
† 8. Disc stem (Part # FP2500-11)
† 9. 10-cup processing workbowl (Part # FP2500-06)
10. Base
11. Cord wrap (under base)
† 12. Non-skid suction feet (Part # FP2500-12)
13. Controls
† 14. 3-cup processing workbowl (Part # FP2510S-13)
† 15. Small, stainless steel chopping blade (Part # FP2510S-04)
† 16. 3-cup processing workbowl cover (Part # FP2510S-07)
† Consumer replaceable/removable parts
Product may vary slightly from what is illustrated.
How to Use
This product is for household use only.
• Remove all packing material and any stickers from the product.
Important: Handle chopping blades and slice/shred disc carefully. They are
very sharp.
• Wash all removable parts as instructed in CARE AND CLEANING section of
this manual.
• Select a level, dry countertop where the appliance is to be used, allowing air
space on all sides to provide proper ventilation for the motor.
ASSEMBLING THE PROCESSOR
HOW TO INSERT AND REMOVE THE CENTER POST:
The center posts of both bowls are removable:
1. Turn the bowl upside down.
2. Grasp the clear outer tabs and turn the center post
clockwise until the lower tabs are free. Lift the post out (B) .
3. To return to its original position, place center post
into smaller opening in bottom of workbowl and turn
counterclockwise until tabs snap into place.
HOW TO LOCK THE LARGE AND SMALL WORKBOWLS IN
POSITION:
1. Attach center post to workbowl. Place the workbowl on
the base with handle turned to the right of the locking
mechanism (C) over the unlock symbol .
2. Hold handle and rotate workbowl clockwise toward the
lock symbol until it clicks firmly into place
(D)
. Be sure
to lock the workbowl in place before attaching the blades
and cover.
HOW TO LOCK THE COVER:
1. Place cover over workbowl with the small latch to the right
of the workbowl’s handle (E) .
2. Hold feed chute of workbowl cover and rotate cover
clockwise until cover locks into place.
B
C
D
A
















E