Controls and Indicators
OPERATING INSTRUCTIONS
Preparing the Unit for Use
This unit is delivered in a partially charged state. Light must charge at least 35 hours prior
to first use for maximum charge to occur. The light charges automatically when it is
plugged into any standard (120V AC 60Hz) wall outlet. The light is fully charged when all
Charge LED Indicators are lit.
When the light begins to dim, recharge for at least 32 hours to achieve maximum run time.
Using the Light in Powerfail Mode
1. Lift the Polarized Plug up to the “out” position and plug the light into any standard
(120V AC 60Hz) wall outlet. Charge LED Indicators will light.
2. When a power loss occurs, the fully charged Rechargeable Power Outage LED Light
will illuminate automatically. With a full charge, the light will run up to 5 hours in
Powerfail Mode.
Using the Light as a Flashlight
1. To use as a flashlight, unplug the light from the wall outlet, push the Polarized Plug to
the down (or “in”) position.
2. Move ON/OFF Switch to the On position.
Note:
Moving the
ON/OFF Switch
to the Off position turns the light Off.
CARE AND MAINTENANCE
This light is weather-resistant, NOT waterproof. Never submerge this light in water. If it
gets dirty, unplug the light from the outlet and gently clean the outer surfaces with a soft
cloth moistened with a mild solution of water and detergent. Make sure the Polarized Plug
is dry before inserting into electrical outlet
ON/ OFF SWITCH
POLARIZED
PLUG
BATTERY
COMPARTMENT
CHARGE LED
INDICATORS
3
FL013B_ManualEN_111407.qxp 11/14/2007 11:37 AM Page 3
