Black & Decker EGBL144, Original Instructions Manual

Page: 6 / 12

6
Read the instruction manual before use.
Labels on tool
The following pictograms are shown on the tool:
WARNING!
To reduce the risk of injury, user must
read the instruction manual.
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Battery
6. Battery release button
7. Charger
8. Bit holder
Assembly
F
Warning! Before assembly, remove the battery from the tool.
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (6) while at
the same time pulling the battery out of the receptacle.
Charge only at ambient temperatures between 4 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
The tool automatically shuts off if the rated current is
exceeded for a longer period of time. As a
consequence the tool will be inoperable. The unit
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
Charge only at ambient temperatures between 4 °C
and 40 °C.
Charging process completed (The LED lights green
continuously.)
Charging (The LED lights up flashing green.)
T3.15A
Fitting and removing a drill bit or screwdriver bit
&
exchange of bits.
Grasp the rear half of the chuck (4) with one hand and use
your other hand to rotate the front half in the
counterclockwise direction, as viewed from the chuck end.
Insert the bit shaft (9) into the chuck.
Firmly tighten the chuck by holding the rear half of the
chuck and rotating the front portion in the clockwise
direction as viewed from the chuck end.