ON-OFF SWITCH (BAIL HANDLE) - FIGURE H
Your mower is equipped with a special on-off switch system. To operate
the system, first push
button H-1
on side of switch housing, then pull the
bail handle (switch lever) H-2
to the
handlebar H-3
.To turn the mower
off, just release the bail handle.
Once the bail handle has returned to the original position it will activate
the “Automatic Braking Mechanism”. The motor is electrically braked and
the mower blade will stop rotating in 3 seconds or less.
MOWER OVERLOAD
To prevent damage due to overload conditions, do not try to remove too
much grass at one time. Slow down your cutting pace, or raise the cut
height.
MEETS CPSC SAFETY REQUIREMENTS
Black and Decker Mowers conform to the safety standards of the
American National Standards Institute, and the U.S. Consumer Product
Safety Commission. The Blade turns when the motor is running.
SAFETY SHIELD AND REAR DOOR - FIGURE I
The
safety shield I-1
is designed to minimize the throwing of stones or
other objects by the mower blade backward from under the mower deck.
The shield, along with the
rear door I-2
, minimizes the possibility of
accidental foot contact with the blade. DO NOT operate mower without the
safety shield and rear door in place.
DANGER:
Sharp moving blade
. For your own safety DO NOT use
this mower without either the grass catcher or mulch insert in operating
position as serious injury could result.
DANGER:
Sharp moving blade
. Do not operate the mower if the rear
door is not closed under spring tension as serious injury could result. Take
your mower to the nearest service center for repair.
REMOVING MULCH INSERT - FIGURE I
To remove the
mulch insert I-3
so that you can bag the grass or
discharge with the optional discharge chute, follow the steps listed below:
1. Release bail handle to turn mower off, wait until the blade stops
and remove safety key.
2. Raise the
rear discharge door I-2
and hold it up.
3. Locate your hand in the
handle pocket I-4
, lift and pull out the
mulch
insert I-3
completely.
4. The rear discharge door is spring loaded. When you release it the
door will return to the closed position.
INSTALLING MULCH INSERT
1. Repeat steps 1 and 2 for removing mulch insert.
2. Slide the
mulch insert I-3
into the discharge opening until it is firmly
in contact with the deck.
3. Release rear door and ensure it is properly closed.
INSTALLING GRASS CATCHER - FIGURE J & K
1. Release bail handle to turn mower off, wait until the blade stops and
remove safety key.
2. Reaching down between the mower handles, raise the
rear discharge
door J-1
to a vertical position and hold the door up. Ensure that the
mulch insert I-3
has been removed.
3. Pick up the
grass catcher J-2
by the
handle J-3
and place the grass
catcher between the mower handles as shown.
10
10
H
1
2
3
J
1
2
3
I
