Note:
Do not exceed the maximum
capacity of 1.5 litres.
Connect the appliance to a suitable
electrical supply. Rotate the switch (8) to
the required speed. Pulse (P) can also be
used to give greater control. When blending
is complete, either release the pulse button,
or return the switch to the off (0) position.
Once the blades have come to a complete
stop, rotate the jar (3) in an anti-clockwise
direction and lift it from the motor housing
(7). Remove the lid (2). Pour the ingredients
into a suitable container.
Note:
Ingredients can be added by inserting
them through the hole left when the filler
cap (1) is removed.
Warning!
Never operate the Blender
without the lid (2) fitted.
Note:
The blender will not operate unless
the lid is correctly fitted.
Note:
Do not operate the blender for longer
than 2 minutes. After each 2 minute session
the blender must be allowed to cool down
for at least 10 minutes.
Note:
The motor is equipped with an auto
resetting thermostat. This may operate and
stop blending if the appliance is over
loaded. If this should happen, allow the
blender to cool down and remove some of
the contents of the jar. The thermostat will
take a few minutes to reset.
As a Coffee Grinder
Remove the cover (13) from the coffee
grinding attachment (11) by holding the cup
and rotating the cover in an anti-clockwise
direction. Add a maximum of 40g of coffee
beans to the cup. Place the cover on the
cup & rotate it clockwise until it locks in
place. Position the assembly on the motor
housing (7), rotate it clockwise until it locks
into place. Turn the knob to the required
speed & allow the grinder to operate.
Note:
The Coffee Grinder should not be run
for longer than 20 seconds. After each 20
seconds use, the Coffee Grinder must be
allowed to cool down for a least 3 minutes.
This can be repeated 3 times before further
use, the unit must be left to cool to room
temperature.
As a Cheese Grater
Cheese should be cut into 15 mm cubes
before grinding. Remove the cover (14) from
the cheese grating attachment (12) by
holding the cup & rotating the cover in an
anti-clockwise direction. Add the prepared
cheese to the cup. Place the cover on the
cup & rotate it clockwise until it locks in
place. Position the assembly on the motor
housing (7), rotating it clockwise until it
locks into place. Turn the knob to the
required speed & allow the grater to
operate.
Note:
The Cheese Grater should not be run
for longer than 20 seconds. After each 20
seconds use, the Cheese Grater must be
allowed to cool down for at least 3 minutes.
This can be repeated 3 times before further
use, the unit must be left to cool to room
temperature.
English
-6-
