A
C
55
DISCONNECT MACHINE FROM POWER
SOURCE.
PROPERLY ALIGN THE BLADE GUARD
AND SPLITTER ASSEMBLY WITH THE
SAW BLADE TO PREVENT KICKBACK.
1. Position the blade 90 degrees to the table and lock
in place.
2. Fasten the splitter support bracket (A) Fig. 9 to the
splitter bracket (B) using two 1/4-20x1/2" hex head
screws (C) and two 1/4" external tooth lockwashers
(D).
NOTE: Loosely tighten the screws for further
adjustment.
Fig. 9
A
B
C
D
ATTACHING BLADE GUARD AND SPLITTER ASSEMBLY
A
A
B
Fig. 7
A
B
C
D
Fig. 6
Fig. 8
Fig. 5
ASSEMBLING BLADE
RAISING AND LOWERING
HANDWHEEL
1. Insert special screw (C) through handle (B) Fig.5 and
assembly handle to handwheel (A) by threading screw
clockwise into handwheel. Then push on handle cover
(D).
2. Fig. 6, illustrates the handle (B) assembled to
handwheel (A).
3. Assemble handwheel (A) Fig. 7, to shaft (B) making
sure the flat on inside of handwheel lines up with flat on
shaft.
4. Fasten handwheel (A) Fig. 8, to shaft (B) Fig. 7, using
a M6x1x12mm flat head screw (C) Fig. 8.
Summary of Contents for BT1800
Page 70: ...70 NOTAS NOTES ...
