Black & Decker BPPP7502, User Manual

Page: 9 / 34

9
ENGLISH
• Switch the tool off after the stroke has been completed.
Rebating (fig. F)
• Fit and adjust the parallel fence.
• Proceed as for planing.
Chamfering edges (fig. G)
The V-groove in the nose piece of the shoe enables you to
chamfer edges at 45°, 30° and 15° angles.
• Hold the tool at an angle with the desired groove (20)
around the edge of the workpiece and perform the
cutting stroke.
Parking rest (fig. H)
Your planer is equipped with a parking rest (21) that
automatically lowers into place when the tool is lifted from
the work surface. When planing, the parking foot raises as
the tool is pushed forward. When the parking foot is lowered,
the planer can set on the work surface without the blade
touching.
Hints for optimum use
• Move the tool along the grain of the wood.
• If the grain is cross or curly, or if the workpiece material
is a hard type of wood, adjust the depth of cut to take
only a very thin shaving at each pass and take several
passes to achieve the desired result.
• To keep the tool in a straight line, press down the front of
the tool at the start, and press down the back of the tool
at the end of the cutting stroke.
Accessories
The performance of your tool depends on the accessory
used. Black & Decker and Piranha accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
The following types of cutting blades can be obtained from
your local retailer:
- Tungsten carbide tipped reversible cutting
blades (part no. X35007, supplied per pair)
- High-speed steel reversible cutting blades (part no.
X24192-XJ11, supplied per pair)
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off and
unplug the tool.
• Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Replacing the drive belt (fig. I)
• Loosen the screws (15) and remove the cover (16).
• Remove the old drive belt.
• Place the new belt (17) over the pulleys. Place the belt
over the large pulley (18) first, then over the small pulley
(19), whilst manually rotating the belt steadily.
• Put the cover back in place and tighten the screws.
Motor brush inspection and replacement (fig. J)
Brushes should be regularly inspected for wear.
• Remove brush cap (22). The brushes should slide freely
in brush box. If brushes are worn down to .3" (8mm) they
should be replaced.
To reinstall, push new brush back into brush box. If replacing
existing brush, maintain same orientation as when removed.
Replace the brush cap (do not overtighten).
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the new
plug.