7
ENGLISH
(Original instructions)
Carbide grout removal blade.
(Part number - X26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
removal of wood, chipboard and
Carbide rasp.
(Part number - X26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
Assembly
Warning!
the mains supply.
Hold the tool and squeeze the accessory clamping lever
(3).
Slide the accessory (8) between the shaft and the acces-
sory holder making sure the accessory engages all eight
Release the accessory clamping lever.
Note: Some accessories, such as scrapers and blades can be
Removing a Black & Decker / Piranha accessory
Hold the tool and squeeze the accessory clamping lever
(3).
Pull the accessory from the tool making sure the acces-
sory dis-engages from all eight pins on the holder.
Release the accessory clamping lever.
Warning: Gloves must be worn when removing accessories
as they may become hot during use.
Line up the sanding sheet (9) with the sanding base (4) as
shown.
making sure that the holes in the sheet coincide with the
holes in the base.
Removing a sanding sheet
Pull the sanding sheet off the sanding base (4).
Warning! Never use the sanding base without a sanding
sheet or accessory in place.
Place the spacer (5) onto the collar (10).
Place the alternative accessory (11) onto the collar (10).
Note:
& Decker accessories. Black and decker accessories are
attached using the Super-lok
TM
Tool free accessory clamping
lever.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning!
the location of wiring and pipes.
The variable speed control allows you to adapt the speed of
the tool to the application.
Set the variable speed dial (2) to the desired setting. At
setting 1 the tool will operate at low speed, 10,000 min-1.
At setting 6 the tool will operate at the maximum speed,
22,000 min-1.
To switch the tool on, slide the on/off switch (1) forward
(position I).
To switch the tool off, slide the on/off switch (1) to the rear
(position O).
Flexible scraper.
(Part number - X26140-XJ)
Ideal for removal of elastomer
sealant and other caulking materials.
6
Hints for optimum use
Always hold the tool securely. For precision work, hold the
tool near the front.
Clamp the workpiece whenever possible, especially when
using cutting blades.
Do not exert too much pressure on the tool.
Always use the appropriate type of attachment for the
workpiece material and type of cut.
Regularly check the condition of accessories. Replace
when necessary.
Mark the desired starting point.
Switch the tool on and slowly feed attachments into the
workpiece at the desired starting point.
