Black & Decker BDT30 Series, Instruction Manual

Page: 7 / 20

Page 7
INSTALLATION GUIDE
When you open the box, you should have received:
Portable dehumidifier
User Guide
Castors (4)
Continuous Drain Kit
To Install Castors:
1. Remove castors from the water collection bucket.
For the 70 pint model (BDT70), the four castors can be taken out from the side
of the bucket directly (see fig 1).
For the 30 pint (BDT30) and 45 pint (BDT45) models, check if the castors are
under the lid of the bucket. If so, remove lid to access castors, then replace lid
before operation. (see fig. 2)
2. Tilt the dehumidifier no more than
45 degrees and push to insert the castors
into the base of the unit. Make sure the ring
around the castor is flush against the bottom
of the dehumidifier. (see fig. 3).
SET UP & USE
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Fig. 1
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Fig. 2
Fig. 3