Black & Decker BDCH188, User Manual

Page: 6 / 12

6
Labels on tool
The following symbols are shown on the tool along with
the date code:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers (Not provided with the tool
Batteries
u
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
exceed 40 °C.
u
Charge only at ambient temperatures between 10 °C
and 40 °C.
u
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
u
Use your BLACK+DECKER charger only to charge
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
u
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
u
If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Speed selector
6. Bit holder
Fig. A (not included, sold separately)
7. Battery
8. Charger
9. Charge Indicator
Assembly
Warning! Before assembly, remove the battery from the
tool.
Fitting and removing the battery (fig. B)
u
To fit the battery (7), line it up with the receptacle on
the tool. Slide the battery into the receptacle and push
until the battery snaps into place.
u
To remove the battery, push the release button (10)
while at the same time pulling the battery out of the
receptacle.
Fitting and removing a drill bit or screwdriver bit
This tool is fitted with a keyless chuck to allow for an easy
exchange of bits
u
Lock the tool by setting the forward/reverse slider (2)
to the centre position.