5
English
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet)
with proper grounding to power the refrigerator.
• Avoid the use of three prong adapters or cutting off the third
grounding prong in order to accommodate a two prong outlet. This is
a dangerous practice since it provides no effective grounding for the
refrigerator and may result in shock hazard.
• Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord,
use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the
extension cord must be equal to or greater than the electrical rating of
the appliance.
DO NOT USE EXTENSION CORD LONGER THAN
12 FT.
• Do not install your refrigerator in any location not properly insulated
or heated, e.g. garage, etc. Your refrigerator was not designed to
operate in temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the refrigerator on a hard even surface
away from direct sunlight or heat source, e.g. radiators, baseboard
heaters, cooking appliances, etc. Any floor unevenness should be
corrected with the leveling legs located on the front bottom corners of
the refrigerator.
Electrical Requirement
Installation Limitations
Use of Extension Cords
WARNING:
ELECTRICAL REQUIREMENT - SHOCK HAZARD
WARNING:
USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD
Door Alignment
(see fig. # 1)
1. Remove the top hinge cover by using a flathead screwdriver.
Place the head under the front edge of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head
screw driver.
3. Adjust the door or put a spacer in between and
tighten the screws.
4. Replace the top hinge cover by aligning the rear
of the cover with the rear of the hinge. Press firmly
on the front of the
cover until it snaps in place.
fig. 1
