3
Collets
NEVER TIGHTEN THE COLLET ON THIS TOOL WITHOUT FIRST INSTALLING
A ROUTER BIT IN IT. TIGHTENING AN EMPTY COLLET CAN DAMAGE THE
COLLET.
To change collets, unscrew the collet assembly, as described above, sharply
pull the old collet out of the collet nut and insert the new collet. Push firmly
so that it snaps past the retainer spring in the collet nut.
Controls
IMPORTANT NOTE: Before operating any of the controls, read this whole
section.
QUICK RELEASE BUTTON
PLUNGE RELEASE LEVER
HEIGHT STOP THUMB
WHEEL
Figure 1
Figure 2
Figure 3
1/2"
COLLET NUT
SPINDLE LOCK BUTTON
154708/3339-220 rtr 5/17/02 2:36 PM Page 3
