BKI WDCG Series, Operation Manual

Page: 12 / 39

10
Figure 1. Floor Models - Leveling
Kick Plate Mounting
A black vinyl-covered kick plate is provided for the front, back and ends of each case.
1. In order to install the Kick Plates it will be necessary to remove the End Trim Panels (see
Figure 2). Remove the retaining nuts located inside the base with a 3/8” wrench. From
outside of the case pull the End Trim Panels away from the case.
2. Slide the front kick plate (the wider of the two) behind the lower finished front panel of the case
(see Figure 2).
3. Make certain that the ends of the kick plate are flush with the ends of the lower finished front
panel and that the kick plate is flush to the floor.
4. Drill 5/32” diameter holes in the case base to match the pre-drilled holes in the kick plate.
5. Attach the kick plate to the case base with the black sheet metal screws provided.
6. Mount the back kick plate to the case in the same manner.
7. Set the End Kick Plates into position on the ends of the case flush with the floor (see Figure 2).
NOTE: There are left and right hand End Kick Plates. The longer end flange faces toward the front of
the case with the black side out. The End Kick Plates fit over the ends of the front and back kick
plates and flush to the floor.
8. Carefully slide the End Trim Panels back into position on the case and push and reinstall the
retaining nuts.
9. This unit is designed to be sealed to the floor after it is installed – to conform to NSF Standard 4.
Use Dow Corning RTV # 732 Multi-purpose Sealant or equivalent silicone sealant to seal the Kick
Plates to the floor around the full perimeter of the case.