Electric Pressure Fryer
Operation
18
Table 1. System Programming Procedure
STEP ACTION
DISPLAY
COMMENTS
1 Press
the
FILTER/OFF/FRY
switch to
FRY
.
LOW
2
Press PROG on the keypad.
PROGRAM CODE
3
Input 1712 and ENTER.
PROGRAM SYSTEM
4 Press
ENTER.
PROGRAM
DEGREES
F
This command allows you
to choose the temperature
scale option you want to
use. The display will show
either show
F or
C.
5
Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM DEGREES
X
X refers to the
temperature scale you
have chosen.
6
Press ENTER.
PROGRAM APL TYPE
ELECTRIC
This command allows you
to choose the appliance
type you are using. The
display may show
ELECTRIC, GAS OR ALF.
7
Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM APL TYPE
X
X refers to the appliance
type you have chosen.
8 Press
ENTER.
PROGRAM
MELTCYCL
YES
This command allows you
to set the melt cycle
option. This is normally set
to yes if you are using
solid shortening. The
display will show either
YES or NO.
9
Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM MELTCYCL
X
X refers to the melt cycle
option chosen.
10 Press
ENTER.
PROGRAM
GLBLFLTR
0
This command allows you
to specify the total number
of fry cycles to complete
among all product
programs before a
message is displayed
reminding you to filter the
shortening (filter lockout).
11
Press TOGGLE/CLEAR and
input the number of fry cycles
you want to complete among all
product programs before
enabling filter lockout.
PROGRAM GLBLFLTR
X
X refers to the number of
program cycles you want
to complete among all
product programs before
filtering the shortening.
12
Press ENTER.
PROGRAM SYSTEM
13
Press PROG to exit the
programming mode.
LOW
