background image

 

Keyloader Interface Kit BKR0587 

 

7001-31152-900 Rev. 0320 

Page 2 of 3 

Copyright BK Technologies 2020 

 
 

KEY ASSIGNMENT 
 

Use the PC programming software from BKR0733 to configure the following parameters: 
 

 Global Settings

 

 

 

Encryption Options tab 

1.

 

Configure the radio’s Encryption Key Pick List.  Enter SLN’s (Storage 
Location Numbers) in the table that correspond to the CKR’s (Common Key 
References) entered into the keyloader unit for each key. 

2.

 

If desired, check the box to enable the ‘Clear TX-Mode Warning Beep’ so the 
radio will issue a warning beep when it is keyed up in clear mode. 

 

Menus/Controls tab 

1.

 

Under ‘Main Menu, configure the ‘TX Secure’ function for channels that allow 
switch-selectable transmissions (see 

Sec column 

below).  The function can be 

assigned to the collar switch, a top toggle switch, or to the touchpad button 
menu. NOTE: It is recommended that TX Secure be assigned to the collar 
switch as it is pre-labeled for clear and encrypted selections.) 
If all channels will be locked either encrypted or clear, the TX Secure function 
need not be programmed. 

2.

 

If keypad selection of encryption keys is desired, assign ‘Picklist-KEY’ to a 
programmable button or add it to the ‘Used’ box for menu selection. 

3.

 

If emergency key zeroization is desired, assign ‘Zeroize Keys’ to a 
programmable button or add it to the ‘Used’ box for menu selection. 

 

Zone/Channel Settings 
 

 

Sec column 

– configure each channel’s transmit secure mode as: 

 

 

Clr: radio always transmits in clear mode on the channel 

 

 

Enc: radio always transmits in encrypted mode on the channel 

 

 

Sw: radio transmits according to the state of the ‘TX Secure’ switch  

 

 

Key column 

– assign a default key (from the Encryption Key Pick List) to be used 

when transmitting on the channel.  Channels that are locked clear and analog channels 
will ignore this setting.  

 
 

Key Lock column

 

– 

enter an ‘L’ to lock the default key to the channel.  Any key 

selected from the touchpad menu will be ignored when transmitting in secure mode 
on the channel (i.e. the default key will be always be used when transmitting in secure 
mode on the channel).  

 

Reviews: