- 2 -
Parameter windows
Navigation
Sensitive keys
This window enables defining the field strength meter parameters to receive a satellite signal. In Europe, the most used satellites have
already pre-recorded places(locations). As an example, this application has to allow the ASTRA 19.2°E satellite reception.
- Highlight the « Place » line with the up and down keys.
- Put the field strength meter on the 3
rd
place, named « ASTRA NUM »,with the right and left keys or with the sensitive wheel.
ASTRA NUM place
- Check that the field strength meter is in the same setup as in the previous example. This place contains enough programs of the
ASTRA 19.2°E satellite for this application (digital channels, horizontal/vertical polarity, high/low band).
- The « Thresholds » allow defining the limits for the level measurement. Their setups have already been installed but it is possible to
modify them (reserved to advanced users).
2)
Adjust the satellite antenna
Now, you have to adjust the dish on the ASTRA 19.2°E satellite.
- First,
switch
the remote supply on (LNB supply). Press the «
DiSEqC » key, the following window appears, go to
the « Remote
supply » line with the up and down keys and choose ON in the menu with the sensitive keys. The « VDC » warning light in the front
panel flashes when the remote supply is switched on.
The menu for sensitive keys changes according to the line which is highlit. It enables modifying the selected parameter.
Table with programs
contained in the
place
Satellite frequency
band
Pre-loaded place
(satellite)
Highlit line
Menu for
sensitive
keys
Sensitive
wheel
Direction keys
Sensitives
keys
