Common Command Introduction
13
<pwm dev>={Default unit is "%",value depends on carrier duty cycle} <ask key frequency>={De-
fault unit is "Hz", Value depends on the model.}
<fsk frequency>={Default unit is "Hz", Value depends on the version.} <fsk jump frequency>={the
same with basic wave frequency}
<wave type>={SINE ,SQUARE, RAMP, ARB, PULSE}
<frequency> ={Default unit is "Hz", Value depends on the model.}
<amplitude> ={Default unit is "V", Value depends on the model.}
<offset> ={Default unit is "V", Value depends on the model.}
<duty>={0% to 100%.}
<symmetry>={0% to 100%}
<rise>={Value depends on the model.}
<fall>={Value depends on the model.}
<delay>={Default unit is "S".}
Note:
There are some parameters Value depends on the model, You can read version
datasheet to get specific parameters
Query Format
<channel>:MoDulateWaVe?
<channel>={C1, C2}
RESPONSE FORMAT
<channel>:MDWV <parameter>
<parameter> ={Return all parameter of the current modulation parameters.}
Example
Set channel one modulation type to AM.
C1:MDWV AM
Set modulation shape to AM, and set AM modulating wave type to sine wave.
C1:MDWV AM, MDSP, SINE
Read channel one modulation parameters of which STATE is ON.
C1:MDWV?
Return:
C1:MDWV STATE,ON,AM,MDSP,SINE,SRC,INT,FRQ,100HZ,
DEPTH,100,CARR,WVTP,RAMP,FRQ,1000HZ,AMP,4V,OFST,0V,PHSE, 0, SYM, 50 Read chan-
nel one modulate wave parameters of which STATE is OFF. C1:MDWV?
Return:
C1:MDWV STATE, OFF
Set channel one FM frequency to 1000Hz
C1:MDWV FM, FRQ, 1000
Set channel one carrier shape to SINE.
C1:MDWV CARR, WVTP, SINE
Set channel one carrier frequency to 1000 Hz.
C1:MDWV CARR, FRQ,1000
RELATED COMMANDS
ARWV, BTWV, SWWV, BSWV
2.15 Sweep Wave Command
Description
Sets or gets sweep parameters.
Command Syntax
<channel>:SWeepWaVe <parameter>
Summary of Contents for 4060B Series
Page 1: ......
