BJM Pumps R08, Installation, Operation & Maintenance Manual, Page: 6 / 34

6
The following are recommended installation practices/procedures for the pump. If there
are questions in regards to your specific application, contact your local
BJM Pumps
distributor or BJM Pumps, LLC.
PRE-INSTALLATION INSPECTION
1) Check the pump for damage that may have occurred during shipment.
2) Inspect the pump for any cracks, dents, damaged threads, etc.
3) Check power cord for any cuts or damage.
4) Check for, and tighten any hardware that appears loose.
5) Carefully read all tags, decals and markings on the pump.
If anything appears to be abnormal, contact your
BJM Pumps distributor or BJM
Pumps, LLC. If damaged, the pump may need to be repaired before use. Do not install
or use the pump until appropriate action has been taken.
Lubrication:
No additional lubrication is necessary. The shaft seal and bearings are fully lubricated
from the factory. Seal oil should be checked once per year. See table below.
OIL FILL QUANTITY/TYPE
Pump Models Qty. oil in seal chamber Type of oil
(U.S. fl. oz.) Metric C.C.
R100 9.5 280 ISO 32 NSF Food Grade Oil
R250, R400, R400D, R400P 1.35 40 ISO 32 NSF Food Grade Oil
R750, R1500, R1530, R1520 3.7 110 ISO 32 NSF Food Grade Oil
RX750SS, RX1500SS 4.4 130 ISO 32 NSF Food Grade Oil
R400L, R400L-3 4.4 130 ISO 32 NSF Food Grade Oil
R08, R15 3.7 110 ISO 32 NSF Food Grade Oil
RX08SS, RX15SS 4.4 130 ISO 32 NSF Food Grade Oil