Rev. 1.02
- 24 -
SRP-500
●
n specifies the paper to be tested
●
m specifies a test pattern
n
Paper
n
Test pattern
0, 48
Basic sheet (paper roll)
1, 49
Hexadecimal dump
1, 49
2, 50
Paper roll
2, 50
Printer status print
[Notes]
When the hexadecimal dump is printed by this command, the data which is transmitted
after the command may not be printed because the printer clears the receive buffer. To
avoid this, transmit data from the host after the printer prints the starting message of
the hexadecimal dump.
This command is enabled only when processed at the beginning of a line in standard
mode.
GS I n
[Name]
Transmit printer ID
[Format]
ASCII
GS
I
n
Hex
1D
49
n
Decimal 29
73
n
[Range]
1
≤
n
≤
3
[Function]
Transmits the printer ID specified by n as follows:
Bit
Printer ID
Specification
ID (hexadecimal)
1,49
Printer model ID
SRP-500 series See table
0D
2,50 Type
ID
below
3,51
ROM version ID
ROM version
n = 2, Type ID
Bit
Off/On
Hex
Decimal
Function
Off
00
0
Two-byte character code not supported.
0
On
01
1
Two-byte character code supported.
Off
00
0
Auto cutter not equipped.
1
On 02 2 Auto
cutter
equipped.
2 - - -
Undefined.
3 - - -
Undefined.
4
Off
00
0
Not used. Fixed to Off.
5 - - -
Undefined.
6 - - -
Undefined.
7
Off
00
0
Not used. Fixed to Off.
[Notes]
The printer ID is transmitted when the data in the receive buffer is developed.
Therefore, there may be a time lag between receiving this command and transmitting
the status, depending on the receive buffer status.
