If needed, remove excess body
hair using a razor or an electric
shaver. Clean the skin according
to the instructions given by your
clinic or the person responsible
for treatment. The skin should be
clean and dry when attaching the
electrode.
Quick Guide
- Bittium OmegaSnap
™
1-CH ECG Electrode
Quick Guide
- Bittium OmegaSnap
™
1-CH ECG Electrode
REMOVE
REMOVE
1.
Make sure the electrode pouch is
unopened and check the date
before use. Tear open the pouch and remove the electrode.
2.
Remove the plastic liner (marked
as number 1) of the electrode. Do
not touch the adhesive surface
with fingers.
3.
2
I
2
2
2
2
I
REMOVE
REMOVE
Fix the electrode onto the skin.
Place the top of the electrode
approximately two fingers’ width
below the suprasternal notch.
Optimal signal quality is obtained
when the electrode is fully placed
on top of the thorax and the
bottom of the electrode is above
the diaphragm.
4.
REMOVE
REMOVE
When the electrode is properly
attached, remove the liners from
the sides (marked as number 2).
One at a time, remove to the side
while making sure the electrode
attaches to the skin.
5.
Make sure the surface of the
Faros device and OmegaSnap
adapter are undamaged*.
Connect device to the adapter. To
ensure a good connection, pinch
device and the adapter together
with thumb and index finger.
Attach adapter to the electrode.
Press the device against the
electrode to make sure the snap
fasteners are connected.
6.
1x
Press and release the power
button to start measuring. A
sound and blinking green light
indicate that measurement has
started.
7.
When you want to end the
measurement, press and hold
the power button for approx.
8 seconds. The device beeps
three times and the blinking
light turns off.
8.
8 sec.
Remove the electrode off the skin by peeling back an edge
of the patch and then gently pulling off the rest of the patch.
You can use mild soapy water if necessary. Dispose of the
used electrode in accordance with local waste management
practices. Return the Faros ECG device and the OmegaSnap
adapter to your clinic or person responsible for treatment.
9.
Manufacturing date
Lot number
Use-by date
Manufacturer
Symbols
CE mark
Do not reuse
Follow instructions for use
*If you notice any visual damage (e.g. a crack or dent), please contact your clinic for
further instructions.
Copyright © 2021-11-15 Bittium. All rights reserved. Document number: 5800638A03
Prescription use only**
**USA users please note:
For prescriptions use, use only by designated healthcare professionals
Medical Device
MD