Page 41 of 191
800581-2.11 NeurOne System User Manual.doc
XI100DUSB - HDMI to USB3 video capture dongle
HDMI cable (between video camera and XI100DUSB)
USB3 cable (between XI100DUSB and PC)
NeurOne Video Trigger unit
NeurOne Video Trigger interface cable:
o
Synchronization signal (beeps) to video camera audio input
o
Synchronization trigger pulses to Trigger IN ( A or B)
External microphone (optional)
4.9 Getting NeurOne System operational
1. Connect isolation transformer to Mains power.
2. All NeurOne system (AC powered) devices shall be powered through the
isolation transformer!
3. Charge the Battery Pack(s) of NeurOne system according to the instructions in
chapter 4.14.5 Charging the Battery Pack.
4. Connect each EXG amplifier
power cable
to the Amplifier power supply
connector on the Main Unit. Use the connector
labeled “Amplifier 1” for the
Amplifier 1. Connect the other end of the Amplifier power cable to the Amplifier.
Repeat for all Amplifiers.
If Battery Pack is used, connect the amplifier (EXG or Tesla) power supply
connector on the Battery Pack. Refer the Battery Pack use in chapter 4.14.
5. Connect the
optical cable
to the optical cable connector (Amplifier data transfer)
on the Main Unit: use the connector
labeled “Amplifier 1” for the Amplifier 1.
Connect the other end of the optical cable to the Amplifier. Repeat for all
Amplifiers.
6. Connect
Trigger cable
to Main Unit for external trigger signals.
7. Connect
Ethernet cable
between the Main Unit and Computer.
