P 7
V2
Single series connection：
DRGB Light Effect Start
6
Water Distribution
4
Water Filling Safeguard
5
1.The water goes from outlet A to the inlet of other water cooling parts. (Or
A choose to connect B or C)
2.If choose to connect to B, and then C has to connect to the inlet of the
other water cooling parts.
3.And then connect to the D or E.
4.Choose D or E as the hole for filling water.
Double waterway connection：
1.The water goes from outlet A to the inlet of other water cooling parts.
2.And then from the outlet of the other water cooling parts to D or E.
3.Choose B or C as the inlet or outlet , connect to other water cooling parts
(Free chosen) as a single finished water loop .
4.Choose D or E as the hole for filling water.
→The light bar plug can be connected to the
motherboard, in synchronization with the
motherboard lighting effect. Or select the
serial connection BP-CADRGBY1 and other
DRGB lighting effect accessories to share the
lighting effect control.
motherboard
Choose the color of the dye you like, mix it with pure water. Fill the water into the reservoir from D or E, when there is 90%
full, use the 24Pin , turn on the power, make the air in the loop all be collected to the reservoir and put out, and then go
on to fill in the reservoir to 90% full.(The function of 24 pin: Replaced to connect the motherboard to make the ATX power
turned on and make the pump worked.) Notice: The water must be pure water, can't be replaced by other liquid.
The power of the pump could not be turned on until there is some water in the reservoir.
A
B
C
D
E
12
6
