記得上角要放對應的 LOGO!
[ 2 ]
Installation
Gnd
Nc
Fg
Pwm
Din
Gnd
NC
1
2
3
4
1
2
3
4
Controller
SATA cable
DRGB cable (connects to the motherboard)
Fan cable (connects to motherboard)
Key functions :
1.Control mode : Remote
2.Static brightness : 5 levels
3.Dynamic speed : 7 levels
4.Number of modes : 100 dynamic modes, 11 static modes
5.Power-off memory : Mode, brightness, and speed settings are retained after powering off
6.External speed regulation : The speed of all fans is regulated by an external PWM signal.
7.One-to-one matching lock: Press and hold the white button for 5 seconds to activate the one-to-one matching
lock mode. Press and hold the purple button for 5 seconds to unlock the mode.
Connector Headers :
ⓐ Power input : LED v5V. Rated current: MAX. 6A
Fan v12V. Rated current: MAX. 8A
ⓑ DRGB control : For an LED signal input, the LED strip will show various lighting effects according to the external signal.
The LED signals of the controller and the motherboard can be toggled using the "RC/MB" button on
the remote control.
ⓒ LED1-LED5：For signal output to the LED strip.
ⓓ FAN1-FAN5：FAN1 (red), detects the fan speed. FAN2-FAN5, used for simultaneous operation of multiple fans.
ⓔ Fan speed control: External fan speed signal input, providing PWM signal to control the five fans.
ⓕ 2-pin signal switch: For switching between MCU and external signals.
Short circuit for 3-5 seconds: the external signal controls each LED strip.
Short circuit for 1 second: the MCU signal controls each LED strip.
Notice :
● Please confirm the power voltage before turning the power on.
● Rated Voltage (Fan): DC 12V
● Rated Voltage (LED): DC 5V
Specification：
Controller Hub Specifications
Rated Voltage: DC 12V
Rated Current: <10mA
FAQ :
Remote control
(Battery type : CR2025)
Fault conditions
Analysis
Solutions
LED strip does not work
The cable is not connected
Reconnect the cable
Power supply failure
Replace the power supply
The signal cable is not connected
Reconnect the signal cable
External input does not work
The signal has short-circuited
Find where the short-circuited point is
The signal cable is not connected
Reconnect the signal cable
Single interface does not work
LED strip failure
Replace the LED strip
LED strip is not connected
Reconnect the LED strip
The fans does not work
The power cable is not connected
Reconnect the cable
power supply failure
Replace the power supply
The signal cable is not connected
Reconnect the signal cable
Single fan does not work
The fan failure
Replace the fan
The power cable is not connected
Reconnect the cable
The remote controller does not work
The battery is empty
Replace the battery
Bad remote control or controller failure Replace the remote control or controller
