Bitspower BP-DIO240-TBBK, Installation Manual

Page: 10 / 15

V3
P 5
---Product Warranty Rules---
The warranty will be void if any of the situations below
happen.
【
CPU Water Block
】
- The CPU block and the screws in it has any trace of disassemble.
- The top plate inlet and outlet ports, due to improper use of
external forces, are cracked.
【
Radiator
】
- The fin of the radiator are broken or deformed due to improper
use of external forces.
- The inlet and outlet of the radiator are cracked due to improper
use of external forces.
【 Fitting 】
- There are signs of damage caused by instrument clamping on the
fittings.
【
PUMP
】
- Pump damage from pump operation without any liquid.
- Pump damage caused by water leak on the pump's PCB.
- Water tank has been separated from the pump.
【
Fan
】
- Fan damaged by water leak.
Water
7
Water filling hole
Choose your desired dye color and mix it with pure distilled water. Pour the water mix into the reservoir via the water filling hole. Once the reservoir is
90% full, turn on the power supply for the pump to run and let the air exit the loop. Turn off the power supply when the reservoir is near empty. Repeat
until all the air has exited the loop. (In order to power the pump only, connect the power switch connector to the 24 pin cable of the power supply. This
will allow the power supply to bypass the motherboard and make the pump work alone.)
Notice:Bitspower recommends that consumers add the Bitspower dye to
distilled water or purified water for their water-cooling liquid. If the
consumer chooses different water-cooling liquids, the resulting impu -
rities may cause peeling of the coating on some of the hardware, water
channels blockage by built-up residue, improper operation of the water
pump, water tank tube breakage, and o-rings deformation leading to
leakage. Any issues related to the use of inappropriate water-cooling
liquid will be the responsibility of the consumer.
Do not turn on the pump if the reservoir is empty.
5
4
10