15
+380 44 507 02 07
Delete all previously set bus parameters -
canobdclr;
If it is necessary to use the tracker after testing on another vehicle, after
connecting the tracker to the diagnostic connector of a new vehicle and
engine establishment, send the command
canobdclr;
After accepting the
command, the tracker sends in response a confirming text
OBD-II
SETTINGS CLEAR OK
.
Basic Device Configuration
Once a mobile carrier SIM-card is inserted and power supply is
connected, the device needs to be configured for transferring data to the
server. When the
Bitrek Configurator
is used, all configuration settings
will be divided into groups:
Server and GPRS
Tracking
Safety
Service
Voice communication
Roaming
The settings required for the basic operation of the device include
data transfer and tracking settings. They are included to the "Server &
GPRS" and "Tracking" groups. Once the appropriate settings are
configured, the device will start transmitting the data of its current
location to the server.
All configurable settings are given in
Addendum 1
.
Security Settings
To comply with the security regulations, access to the device
configuration settings may be restricted.
When connecting the device to a computer by means of USB-UART
adapter, the device access password must be entered every time, when
sending the commands to the device.
Default password is 11111. The password is valid for 60 seconds
once sent. Once this time lapses, the password needs to be entered
again. Access password can be changed by a user.
The default password must be sent to the device in the following format –
TPASS: 11111;
Example of a response:
"TASK COM TERM: PASSWORD OK"
– the password is correct;
"TASK COM TERM: INCORRECT PASSWORD"
– the password is
incorrect;
