www.BISSELL.com
8
Cleaning Your Sealed Hard Floors
Press the ON/OFF
button to start cleaning
your sealed hard floors.
To clean,
push the
SPRAY
button to
dispense
solution.
Solution will spray
out of the nozzle on
the front of the foot.
You should hear a
soft buzzing noise
each time you press
the SPRAY button
to indicate solution
being dispensed.
For more difficult and stuck on messes, spray solution directly on mess and line
up one of the mop pads parallel to the mess. Move mop pad over mess and slowly
move machine back and forth to clean, continuing to spray solution as needed.
2
4
6
Recline
the body
of the unit
backward
to start the
rotating
mop pads.
3
Plug machine into a
properly grounded
outlet.
1
5
TIP:
For optimum cleaning, perform overlapping cleaning strokes while dispensing
cleaning solution. Care should be taken to not over wet the floor surface, especially
when cleaning wood and other delicate floor surfaces.
ATTENTION:
This machine is designed to be used only on sealed hard floors and should not be
used on carpet or rugs. For best cleaning results, sweep or vacuum the floor surface prior to
using the BISSELL SpinWave
™
. This is to avoid scratching or damaging floors from sharp debris.
TIP:
You may feel a slight vibration when turning on the machine if the mop pads are
not aligned correctly. Wait a few seconds for the pads to adjust themselves. If this
doesn’t occur, turn the machine OFF and replace mop pads following the instructions
in “Attaching Mop Pads” section.
NOTE:
When finished cleaning, make sure to push the OFF button before standing the
machine upright as the mop pads will continue to spin until the machine is turned OFF.
TIP:
When cleaning near baseboards, edges, or furniture you may feel a slight pull
from the unit due to bouncing off the surface.
