Bissell PROHEAT ALL-ROUNDER, User Manual

Page: 10 / 40

10
w w w . b i s s e l l . c o m
Getting ready to wet clean
NOTE: Remove tool caddy if in place.
1. Attach the desired wet cleaning tool to end
of wand or grip.
2. Open the Quick Release™ Hose Door and
select “WET CLEAN” with the mode selector.
3. Place the clean solution tank on a
flat surface.
4. Fill the solution tank by first unscrewing the
measuring cap. Always use genuine BISSELL
2X formulas to maximize cleaning and for the
safety of your machine. Fill tank to fill line with
hot tap water. Add two full measuring caps of
formula. Screw measuring cap tightly back
onto the solution tank.
5. Place the solution tank back in
the machine.
6. Make sure the float is in place. To install,
slide float into the channel located on "Fill
Line" side of the collection tank. There is
only one way to properly install the float.
7. Plug into a proper outlet and press the ON/
OFF, wet clean and heater (if desired) buttons
down into the ON position.
Note: Allow one minute for the built-in
heater to warm up before cleaning. The
PROheat All-Rounder will be fully warmed
and will provide optimal performance after
one minute in the heater ON position.
O
peration
Tip:
Move furniture to another area
if cleaning an entire room.
2
4
5