w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
5
You need: Phillips head screwdriver.
attach handle to vacuum
1.
Locate the vacuum handle and remove
the screw packet taped to the base of
the handle.
2.
Stand the vacuum upright and slide the
base of the handle firmly into the grooves
at the top of the vacuum body.
3.
Insert the screws provided from the screw
packet into the existing holes. Tighten
securely with a screwdriver.
attach vacuum hose and tools
1.
Line up tabs on the base of the Twist
‘n Snap™ hose with the corresponding
notches on the hose collar. Turn the
hose to the right to lock into place.
2.
Grasp the Hose Wand and slide the
end of the hose wand into the hose
wand base. Snap the hose into the
upper hose clip on handle.
3.
Slide the extension wand and crevice
tool together into storage clip.
4.
Snap the combination tool into the
storage clip.
5.
The TurboBrush® Tool bracket slides
into the front of the handle. Attach the
bracket by aligning the pegs with the
holes on the handle and pulling down
until it locks into place.
6.
Place the TurboBrush® Tool in the
bracket by aligning the bottom of
bracket with the opening of the brush
roll and snap the TurboBrush® Tool
into place.
2.
3.
1.
5.
6.
4.
3.
