w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
O
perations
10
Dust bag replacement
1.
Unplug the vacuum from electrical outlet.
2.
Disconnect hose
3.
Open the dust bag compartment by
lifting up on the latch on the door on
the front of the vacuum.
4.
Lift out the dust bag holder and dust bag.
5.
Release the dust bag from the holder
by pressing the dust bag holder clip
and pulling the dust bag out of the
holder. Discard the used dust bag.
6.
Slide the new dust bag into the
holder by inserting the dust bag into
the tabs located at the bottom of
the holder. Then press the dust bag
holder clip, insert the dust bag and
release the dust bag holder clip to
hold the dust bag in place.
7.
Place holder and new dust bag
back into the dust bag compartment,
making sure the entire bag is tucked
in below the seal gasket.
8.
Close dust bag compartment door
and press down gently until it locks
into place.
NOTE: The dust bag compart-
ment door will not close with-
out the dust bag in place.
9.
Reconnect hose.
3.
4.
5
WARNING:
To reduce the risk of electric
shock, turn power switch OFF
and disconnect plug from
electrical outlet before
performing maintenance or
troubleshooting checks.
