When you are done using your vacuum, return it
to the Upright position and store the Power Cord.
Turn vacuum cleaner off.
Unplug Power Cord by grasping the polarized plug (NOT
the cord) and disconnect from outlet.
Loop Power Cord around Cord Wraps on side of vacuum
cleaner.
Clip molded plug to Power Cord to secure.
To maintain maximum cleaning performance, the
following maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the
“Full” line on the side.
Check the Inner and Outer Circular Filters, and the
Pre-Motor Filter at least once a month and clean or
replace as needed.
Clean or replace the Post-Motor Filter every three to
six months.
Note: More frequent filter cleaning or
replacing may be necessary if you are
vacuuming new carpet, fine dust, or have
allergy concerns. Follow the instructions on
the following pages to perform these simple
maintenance steps.
The Dirt Container needs to be emptied when the dirt
reaches the “Full” line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to
remove from vacuum.
Empty dirt into garbage container.
Put the Dirt Container back in the vacuum and slide the
lever to the "Lock" position.
Note: The Dirt Container may be washed in
warm water with a mild detergent. Remove
the Filter Cup from the bottom before
washing. Reassemble and make sure it is
completely dry before using again.
1.
Power Cord Storage
8
How To Maintain Your Vacuum
2.
3.
4.
1.
2.
3.
Empty Dirt Container
1.
2.
3.
4.
5.
Tip:
For maximum cleaning
performance, check
and clean or replace
all filters as suggested.
WARNING:
To reduce the risk of
electric shock, turn
Power Switch OFF and
disconnect polarized
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
Full Line
Lock Position
Unlock
Position
NOTICE:
While vacuuming, certain carpets
and low humidity conditions may
generate small static discharges.
The discharges are entirely
harmless and are not associated
in any way with the main
power supply.
