w w w . b i s s e l l . c o m
10
o
perations
Ready Tools™ continued
7.
Set the ReadyTools dial to the TOOLS
setting. This will allow spray and suction
from the hose.
8.
Attach the cleaning tool to the end of
the hose.
9.
Clean by pressing the spray trigger
to spray solution onto the area to be
cleaned. Slowly move the tool back and
forth over the soiled surface. Release
the spray trigger to suction dirty water.
Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10.
When finished cleaning, remove and
rinse tool(s) in clean, running water.
11.
It is recommended that you suction clean
water from a bowl to rinse out the hose.
12.
Before wrapping hose onto tool rack, lift
end of hose and stretch out to ensure all
water is cleared from hose.
13.
Wrap flex hose around tool rack.
14.
Empty 2-in-1 water tank and rinse out,
following instructions on pages 9
through 10.
15.
If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean,
first remove nozzle and locate screw
that holds the diverter assembly in place.
With a Phillips screwdriver, remove the
screw and set aside.
16.
Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the
dial about 10 times clockwise and
10 more times counter clockwise. This
should free up any debris.
17.
Wipe diverter assembly with a soft cloth
and replace back on machine. Replace
nozzle.
18.
Return ReadyTools dial to
FLOOR CLEANING setting.
Cleaning with Deep Reach™ Tool
1.
Set tool on soiled surfaces and press the
spray trigger to spray solution onto the
soiled area to be cleaned.
7.
15
.
12.
16.
Screw
Run water through here
Tip:
To clean with sliding
crevice tool, slide brushes
forward to clean stain, slide
back to suction
11.
1.
