w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
7
O
perations
Getting ready
1.
Attach mop pad
A.
Set the mop pad flat on the floor
B.
Line up the mop head and place it
inside the mop pad with cord located at rear
of mop head. Tighten cord to ensure tight fit.
2.
Fill water tank
A.
Remove tank by lifting straight up and
away from the unit.
B.
Unscrew cap and remove from tank.
C.
Fill water tank with water. For best
results, water should be at room temperature.
D.
Replace the assembly cap and tighten
until snug.
E.
Replace water tank by lining up vertical
guides and gently sliding tank into place.
3.
Select a steam control setting. Light is for
delicate floors such as hardwood and lami-
nates. Medium is for everyday cleaning,
and Tough is for hard to clean messes.
4.
Twist the quick release cord wrap clock-
wise to unwrap the power cord completely
and plug into a 120-Volt grounded outlet
as described on the Important Safety
Instructions, page 3.
5.
The ready light will illuminate in 30
seconds when the Lift-Off Steam Mop is
ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior
to cleaning with the Lift-Off Steam Mop.
Cleaning hard floors
Your Lift-Off Steam Mop is designed
to clean hard flooring such as ceramic
tile, vinyl, laminate, marble, stone and
sealed hard wood floors. Use of your
Lift-Off Steam Mop on waxed or some
unwaxed floors may result in a dimin-
ished glossiness. The Lift-Off Steam Mop
is not for use on unsealed wood floors.
For best results test in an inconspicu-
ous area and check the care instructions
from your flooring manufacturer.
2A
2B
2D
2E
