Bisonte PAZ-6860E, User Manual

Page: 62 / 72

Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
62
Interruption work, stopping work
1. Turn pressure control valve to “low”.
2. Turn relief valve knob to “open”
3. Run for 1-2 minutes with throttle lever in the “low speed” position.
4. Switch off engine.
5. Close fuel cock
Shut-down and maintenance procedures
1. Check that pressure is at zero then activate safety lock on airless gun and remove
nozzle tip. 2. Check that relief valve is at "open" and pressure control valve is at "low"
then remove suction hose from paint and start engine. 3. Slowly turn pressure
control valve to "high" and once a certain amount of paint has run out of return
hose place suction hose into cleaning fluid#.
#Cleaning fluid is defined as a solvent, water etc. that is appropriate to the paint.
Oil-based paint - solvent Water-based paint - water
Caution!
Don’t increase pressure to such an extent that paint or cleaning fluid spray out.
4. Once cleaning fluid has run out of return hose, turn relief valve to “close”,
disengage safety lock on airless gun, pull trigger and purge paint out of hose.
5. Once cleaning fluid has run through tip of gun, recycle fluid in that state for a
short time in order to clean out the paint system.
6. Remove suction hose from cleaning Fluid and purge cleaning fluid in paint Hose
from airless gun.
7. Turn relief valve to “open”, purge cleaning fluid in return hose and finish by turning
pressure control valve to “low”.
8. Remove suction filter and nozzle and clean away any build-up of matter or paint
Caution!
When not in use for an extended period totally purge cleaning fluid and fill suction
valve with rust-proofing oil to prevent seizing.
Never discharge paint waste or waste cleaning fluid into natural water systems,
sewers etc. request removal by an industrial waste collector.
Shut