2
5.
Attach one
Band Clamp
(C) with
5/16” x 2” Carriage Bolt
(H), and
5/16” Flange Nut
(I) approximately 12” from the
bottom end of pole and insert pole into concrete
while vibrating concrete to allow it to surround
the pole completely. The horizontal extension
section of the pole should be parallel to the
playing surface, perpendicular to the intended
court end line and the lower surface of the
horizontal portion of the tube should be
9’ 6” (except PR78, which should measure
9’ 6 1/2”) above the playing surface. You will
need to brace the pole to maintain this dimension
to insure the rim height will be at official 10’.
See Figure 13.
6.
Trowel the top of the concrete smooth and clean any excess off the
Gooseneck Pole
(A).
Allow the footing
to cure for at least 48 hours.
Do not proceed any further until concrete is completely cured.
7a.
On systems PR74, PR78, PR79, PR79XL, PR87 and PR87XL, assemble
Backboard Conversion Plate
(U),
Backboard Mounting Adapter
(B),
Backboard
(P) and the
Rim
(Q) using the hardware provided with the
Backboard Conversion Plate
(U). See Figure 2.
7b.
On systems PR75, PR75XL, PR76, PR77, and PR77XL, assemble
Rim
(Q),
Backboard
(P) and
Backboard Mounting Adapter
(B) using the hardware provided with the
Rim
(Q). See Figure 3.
7c.
On Systems PR87, PR87XL assemble
Backboard
Conversion Plate
(U),
Backboard Mounting Adapter
(B),
Backboard
(P) and two
Backboard Spacer Plate
(V)
using the hardware provided with the hardware provided
with the
Backboard Conversion Plate
(U). See Figure 4.
8.
Slide two
Band Clamps
(C) onto the horizontal portion
of the
Gooseneck Pole
(A). See Figure 5.
FIGURE 1
FIGURE 3
FIGURE 2
FIGURE 4
