1
P A R T S L I S T
Item
Qty
Description
Item
Qty
Description
A
1
Portable Base and Pole Assembly
J
1
Acrylic Backboard Hardware (pkg. w/ backboard)
B
1
Extension Arm Assembly
K
1
Backboard (pkg. separately)
C
2
Upper Backboard Support Brackets (BA832/833)
L
1
Goal (pkg. separately)
D
2
Lower Backboard Support Brackets (BA832/833)
M
1
Goal Mounting Hardware (pkg. separately)
E
4
Backboard Mounting Angles (BA832/833)
N
4
5/16”
X 1
1/2”
Carriage Bolt (BA832)
F
8
5/16”
X
1”
Hex Bolts (BA832/833)
O
1
Locking Pin
G
12
5/16”
Flange Nuts (BA832/833)
P
1
Lock Knob
H
8
5/16”
Flat Washers (BA832/833)
Q
1
Backboard Mounting H
-
Frame (BA833XL)
I
1
Height Indicator Labels (attached to base)
Warning!
Do not release the height adjustment handle or loosen the telescoping pole lockbolt until the system is
completely assembled as the telescoping tubes are under spring tension and may cause damage or injury to
the assembler.
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
Carefully read all instructions before proceeding. Pay special attention to the safety instructions on the next page.
Save this instruction in the event that the manufacturer must be contacted in the future for maintenance
information.
Date: 10/19/2020 Rev: 9 B.A. N.J.C. File: \PUB\BA833 Ref#: 930306
——
Instruction Manual ——
BA832/833/833XL
Portable/Adjustable Basketball Systems
Customer Service
(800) 247
-
7668
1.
This basketball system is shipped partially
preassembled. After removing the system from its
shipping skid open the lower padded front of the
unit by removing the
Lock Knob
(P) and pulling
forward on the top of the lower pad. Remove the
unassembled parts and hardware. See Figure 1.
2.
For BA832/833 open the rear ballast storage
compartment by removing 4 screws. Do not
remove the bottom 2 pivot screws. Pivot rear
cover open and place 12 each
4”
x
8”
x
16”
solid
Concrete CAP Blocks and 3 each
4”
x
8”
x
8”
Solid
Concrete CAP Blocks into the compartment.
Make sure that the weight is evenly distributed.
Reposition the rear cover.
See Layout 1.
P
Figure 1
