30
11-12 Hydraulic oil
<Hydraulic oil replacement>
1. Replace the hydraulic oil one year after start of use. From the second time and on, replace the full
amount every three years.
1. Remove the hydraulic unit cover.
2. Remove the drain plug (arrowed in the right figure) from the
bottom of the oil tank to drain the hydraulic oil.
After drainage, replace and tighten the drain plug securely.
3. Remove the top lid from the oil tank to check the condition of the
suction filter. A dirty or rusty filter must be cleaned, replaced, or
otherwise appropriately treated.
4. Fill the specified amount (8 liters) of hydraulic oil from the top of
the oil tank.
5. Raise the lift to check for normal operation.
Note that this product uses a gear pump, the performance of which is significantly affected by the
hydraulic oil used. Be sure to select an appropriate brand from the table below.
Viscosity grade ISO VG32 Wear-proof hydraulic oil (amount to be used: 8 liters)
I d e m i t s u
Super Hydraulic Fluid 32
JX
Nikko-Nisseki
Super Hyrando 32
E S S O
Nuto H 32 Unipower SQ 32 and XL32
Mobil
Mobil DTE Oil 24
Showa Shell
Terrace Oil 32 and K32
*Use extreme care to avoid touching any high-voltage parts during inspection.
*After performing inspection with the cover and associated parts removed, replace them
back in place using all mounting screws.
*If an inspection reveals any anomaly, immediately prohibit the use of the lift and contact
your dealer for corrective action.
Caution
Hydraulic unit cover
Oil tank
Drain plug
Replacement method
Summary of Contents for NSA3500N
Page 38: ...37 MEMO...
Page 39: ...38 MEMO...
