BIRO Mini-32, Operating And Service Manual, Page: 12 / 32

9
REMOVAL & INSTALLATION INSTRUCTIONS
PADDLE REMOVAL:
Remove mixing paddle by first locating and lifting up on the hopper lock down clamps releasing them
from the hopper. Next loosen the paddle lock knob (four point knob located at the front of the hopper).
Then turn the locking lever clockwise approximately ¼ turn and remove to unlock the paddle shaft
from the hopper. Slide paddle shaft toward front of hopper and lift drive end up and out to remove
paddle.
PADDLE INSTALLATION:
Install paddle shaft by first connecting the driven end of the paddle shaft to the driver hub.
Insert the locking lever and tighten the paddle lock knob.
HOPPER REMOVAL:
After the paddle shaft has been removed, be sure the hopper lock down clamps have been lifted and
lock down rods extracted from the hopper anchor releasing them from the hopper. The hopper is now
ready for removal.
HOPPER INSTALLATION:
Place the hopper on top of the grinding bowl assembly with the lock arm retainer facing toward the
front of the machine. Connect the hopper lock down rods to the hopper anchors and lower the lock
down handles to lock the hopper in place.
AUGER ASSEMBLY REMOVAL:
Loosen the retaining ring and remove knife and plate. Now the auger can be pulled out from grinding
bowl.
GRINDING BOWL ASSEMBLY REMOVAL:
After the paddle shaft, hopper, retaining ring and auger assembly have been extracted, the grinding
bowl can be removed by lifting the output end of the assembly and pushing toward the cabinet. Next
lift the bowl lock hooks and seperate the bowl assembly from the machine.