BIRO FBC-4800SS, Operating Manual And Parts List

Page: 7 / 28

INSTALLATION
TO AVOID SERIOUS PERSONAL INJURY, PROPERLY INSTALL
EQUIPMENT IN ADEQUATE WORK AREA
·
ALWAYS Use Qualified Technician and Electrician for Installation.
·
ALWAYS Connect to Proper Voltage & Phase.
·
ALWAYS Install Equipment in Work Area with Adequate Light and Space Away From Children
and Visitors.
·
ONLY Operate on a Solid, Level, Non-Skid Surface.
·
NEVER Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
·
NEVER Operate With Product Chute Cover in Open Position.
·
NEVER Operate Without all Warning Labels Attached and Owner/Operator Manual Available to
the Operator.
UNCRATING AND SET UP
1. Read this Manual thoroughly before installation and operation.
Do not
proceed with installation and operation if
you have any questions or do not understand anything in this Manual. Contact your local Distributor, or BIRO
FIRST.
2. Carefully remove cardboard crate wraparound. Remove meat lug dolly and set aside.
3. Remove
3
8
bolt and nut holding machine to wood crate bottom.
4. Remove Meat Lug (Item No. 51199-MHD) from top of machine.
5. Install casters (3 ea. Item No. 51165 less brake and 1 ea. Item No. 51164 with brake) on the stainless steel Meat
Lug Dolly (Item No. 51582) with supplied fasteners. Set Meat Lug and Dolly aside.
6. With assistance of mechanical devices lift machine and block up. Remove machine legs from side of machine.
Replace legs to same mounting holes in vertical position, tightening the acorn nuts on the carriage bolts.
7. Remove stainless steel Chute Cover (Item No. 51597) from top of machine. Turn over and mount to stand offs at
top of chute opening. Tighten Chute Cover Hinge Pins (Item No. 51563). Do not over tighten. Chute should be
centered and still have free movement to open and close. Magnet should be centered over safety switch.
Tighten jam nuts on hinge pins.
8. Install Chute Cover Support (Item No. 51404) to Chute Cover. Be sure bushing is used to allow free movement
of chute support. Be sure chute support is in lock bracket welded to side of chute.
9. Place machine on a level, solid, non-skid surface in a well-lighted work area away from children and visitors.
10. Install floor stops over the front leg pads (opposite motor end). It is recommended that floor stops be anchored
to the floor with two
3
8
-16
´
1
1
2
" expansion anchors per floor stop.
3