background image

3

Operation

The Insect Killer is activated by the on/off switch, when turned on, the light tubes will be illuminated.
Note: Light travels in straight line, therefore any interference from large objects in the light path will affect the 
efficiency of the Insect Killer, if objects block the light, several units may need to be installed.

Cleaning, Care and Maintenance

The Insect Killer should be cleaned regularly, depending on the environment, this would usually be every 3-4 
weeks. 

Switch off power to the Insect Killer and disconnect from the mains. The black safety grids can be simply 
brushed down with a soft bristle brush. The outside of the unit can also be wiped down with a damp cloth. 
Remove the collecting tray from the bottom of the unit and discard the matter, and wipe over with a damp 
cloth.

Do not immerse in water.

A disinfectant solution is recommended for use, when wiping down the Insect Killer.
To maintain efficiency it is recommended that the light tubes should be replaced every 9 months approximately.

Safety

*The Insect Killer does not contain any user-serviceable parts. Only Birko agents or recommended qualified 
technicians should carry out repairs if necessary. Do not remove any other components or service panels on 
this product.

*Birko takes every care to ensure that all products are safe. Steel cutting procedures used to manufacture 
these items May result in sharp edges, these sharp edges are removed to the best of our ability however we 
insist the operator takes care when in contact with metal edges 

*Switch off power to and disconnect from the mains whilst cleaning.

*Whilst the Insect Killer is in operation do not place your hand or any other objects into the unit.

*This appliance is not intended for use by persons (Including Children) with reduced physical, sensory 
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or 
instruction concerning use of the appliance by a person responsible for their safety.

*Children should be supervised to ensure they do not play with the appliance.

Summary of Contents for BK1004101













Reviews: