RF Calibration Kit
16
VESA Mount
The 4421A is designed to attach a VESA mount with two 75mm spacing holes. There are two screw locations located
on the rear of the 4421A enclosure, see
Mounting Hardware
The following hardware is required (not supplied) to mount the 4421A.
Two screws, thread-Forming, for thin plastic, M2.5 size, 10 mm long
Two oversized washers, M2.5 screw size, 2.7 mm ID, 8 mm OD
VESA Mount with 75mm hole spacing
VESA Mount Installation
1. Position the VESA mount on the rear of the 4421A enclosure.
2. Insert the recommended screws into the washers, then drive screws into the indented holes on the rear of the
4421A. The screw will break through a thin plastic barrier.
3. Lightly hand tighten until snug.
Figure 12 VESA Mount
CAUTION
Do not over tighten the screws. Over tightening will strip the plastic and the screw will not
hold the 4421A to the VESA mount.
Summary of Contents for SMK-3000 Series
Page 2: ......
Page 38: ...RF Calibration Kit 28 Figure 13 Sensor Accuracy Vs Load VSWR...
