two speaker wires from the 20 speaker tower to
the speaker terminals on the generating unit.
Connect the solar panel to the battery matching
the positive and negative terminals on both ends.
(Fig. 2)
3) It is recommended to mount the 20 speaker
tower on a pole or surface that is aimed directly
and at the same level as the infected area.
4) Set the Recording switches, Mode Setting
switches, Time-Off switches, Time of Operation
switches and Random Operation switches to
the desired settings. (See PROGRAMMING
YOUR MEGABLASTER for complete details
on how to program your bird repeller).
5) Make sure the volume setting is set to LOW (all
the way counterclockwise).
6) Slide the power switch to the ON position. The
unit may take a few seconds before starting.
7) Adjust the volume to the desired level.
8) Close the cover and latch shut.
PROGRAMMING YOUR
MEGABLASTER
To program your Megablaster unit you will need
a small screwdriver, toothpick, or other small, rigid
object to toggle the switches in
the switch array. The switch
array is the switch bank located
in the top left corner of the unit
(under “PROGRAM”) . A switch
is ON if the switch is pressed
down on the right-hand side.
The switch is OFF if the left
side is pressed down.
RECORDING SETTING SWITCHES
The Recording switches are the
first eight switches in the switch
array. Each switch has a
recording number to the right of
it that corresponds with the bird
descriptions listed on the foil
label inside the unit.
MODE SETTING SWITCHES
The Mode Setting switches set
the various modes of operation:
such as the amount of time
between playing bird distress
calls, when the unit will operate (day only, night
only, or 24 hours), and whether the unit will
operate in the Random Mode or Normal Mode.
Switch
Mode or Function
1
Sets the Time-Off Period
2
Sets the Time-Off Period
3
Sets the Time the unit plays
4
Sets the Time the unit plays
5
Turns Random Mode On or Off
TIME-OFF SWITCHES
The two Time-Off switches
are located just below the
Recording switches
in the
switch array.When the unit is
set to one of the various Time-Off modes, the unit
will delay a number of seconds or minutes
between recorded sounds. Please note that the
unit will play all of the selected recordings (either
sequentially or non-sequentially, depending on the
Random Mode) then it will go into a delay. The time
the unit stays off depends on the Time-Off and the
Random Mode settings. If the unit is operating in
Random Mode, the unit will delay anywhere from
the minimum value to the
maximum value for that
time-off setting. If the unit is
not in Random Mode, it will
delay only the minimum value. To set the Time-Off
period (or delay interval), use the following settings
on switches 1 and 2 in the mode function settings.
Switch 1 Switch 2
Time Off Period
ON
OFF
Short
OFF
ON
Medium
ON
ON
Long
OFF
OFF
Extra Long
Mode
Min
Max
Short
17 sec
50 sec
Medium
1 min
4:15 min
Long
5:00 min
10:00 min
XLong
10 min
30 min
TIME OF OPERATION SWITCHES
The two “Day/24hour/Night”
switches are located just
under the Time-Off
switches
in the switch array.
‘Night Mode’ operates the unit at night and ‘Day
Mode’ operates the unit during the day. However,
the photocell that senses the sunlight is susceptible
to bright lights. Take care not to have bright lights
shining towards the unit since this can prevent the
unit from operating properly. In 24-hour mode, the
unit will operate continuously, regardless of the time
of day. To set the time period for the unit to oper-
ate set switches 3 and 4 in the Mode Function set-
tings to the following:
Switch 3 Switch 4
Mode
ON
OFF
Day Only
OFF
ON
24-Hour
ON
ON
Night Only
OFF
OFF
also Night Only
RANDOM OPERATION SWITCH
The “Random” switch is the bottom switch in the
switch array. When operating in Random Mode, the
unit will randomly play the selected recordings in
non-sequential order. When the unit is not operat-
ing in the Random Mode, the unit will play the
RECORDING #1
RECORDING #2
RECORDING #3
RECORDING #4
RECORDING #5
RECORDING #6
RECORDING #7
RECORDING #8
TIME OFF
DAY/24HR/NIGHT
RANDOM
123
456
7
8
12345
RECORDING
Switches (1-8)
HARASSMENT #8
TIME OFF
DAY/24HR/NIGHT
RANDOM
81
2
3
4
5
Mode Setting
Switches (1-5)
RECORDING #8
TIME OFF
DAY/24HR/NIGHT
81
2
3
TIME OFF
DAY/24HR/NIGHT
RANDOM
12345
TIME OFF
DAY/24HR/NIGHT
RANDOM
2345
RECORDING #1
RECORDING #2
RECORDING #3
RECORDING #4
RECORDING #5
RECORDING #6
RECORDING #7
RECORDING #8
TIME OFF
DAY/24HR/NIGHT
RANDOM
123
456
7
8
1
2345
Wiring Setup Diagram
Fig. 2
(Not Included)
