If beam seems weak/fuzzy:
1.
This could be due to a long time of operation without a break, or a high operating temperature, neither of
which is recommended. If this is occurring in a normal temperature environment with periodic breaks, try
turning off the unit to cool for 30 minutes before turning it on again. After 5 minutes (longer in cold
weather) the beam should no longer be weak/fuzzy.
2.
This could be due to a dirty mirror. Check mirrors and clean (according to “cleaning” section).
If problems cannot be solved please contact your dealer for service
In particularly stubborn and/or long-term infestations, it may be necessary to consider a combination approach to
further decrease the desirability of the facility to birds. Please see the SYNERGY AND OTHER PRODUCTS section
below.
Housekeeping is very important! As mentioned in the Bird Management Program, the problem area should be
cleaned of all evidence of birds. Nest, fledglings, droppings, dead birds, and the residual scent should all be removed.
Check the area for unusual incentives. Remove food spillage, garbage, nesting materials and other items that may be
appealing to birds.
VIII.
PRECAUTIONS
This laser is Class I. The power of each laser point is no more than 1 milliwatt, which is not harmful to the human
body or eye.
Read and observe all safety labeling on this device.
Never look directly into laser beams, or into the specular reflection(s) of any beam. Wear safety goggles to
protect your eyes when necessary.
DO NOT point towards other people.
DO NOT direct laser beam up into the sky AT ANY TIME. Significant disruption to safe airplane operation may
result, punishable by federal law.
Wear antistatic wrist strap while servicing to prevent electrostatic damage.
While this unit is weather-resistant under normal conditions, avoid exposure to extremes such as hurricanes.
Do not leave where it may become flooded or immersed. Do not allow to be covered in snow.
Do not place unit in or near water. Do not mount while standing in or surrounded by water.
Do not spill liquids into or onto unit. If this happens, disconnect the power immediately.
Power directly off of a switched circuit; never with a dimmer or rheostat (even a 0 to 100% switch).
Disconnect unit from main power before inspecting, installing, making any type of connection, or replacing
any components.
Locate this unit with adequate ventilation, at least 15 cm from a wall, and mount in a safe, stable manner.
To prevent fire or shock hazard, do not expose this unit to a high temperature or high humidity area. Unplug
unit when not in use.
Keep away from combustible materials.
Lasers are regulated by the FDA. Accession numbers are on file. You may also visit the FDA web site for more
information.
For outdoor use, install at ground level or a few inches above the ground.
Do not project beams onto specular (reflective) material – for example, mirrors.
Do not project beams at room entrances.
Do not use near humans or pets.
